Description
Dimafix Glue (90 ml)
Dimafix Pen (90ml) is a new product based on the Dimafix Spray formula. The Dimafix Pen maintains the same adhesion properties of Dimafix Spray format but in dabber liquid bottle format. It has been known to last as much as 100 uses (your mileage may vary depending on bed size). It is water soluble so it is easy to clean. It works on a wider range of temperature than the Dimafix Spray, so it allows the self detaching effect of the piece sooner. This product does not contain any gas, is environmentally friendly. You can also notice it great smell during the print. After you use it, close it and hold it properly.
Usage:
- Shake it the bottle a few seconds before applying.
- Make sure the base is cold
- Apply it over the base
- Wait a few seconds for the surface to dry and heat the bed
- Consult the table with recommended temperatures for printing each Dimafix formula
- The product begins to work above 65ºC/150ºF
- While the bed keeps over 85ºC / 185ºF the pieces will remain stuck on it
- In case of incident during printing try not to remove the piece. If the piece has not taking off yet, when bed will be heated again the piece will adhere tightly and maybe you could recover your work
- After printing finished the piece will be easily detached (below 50ºC/122ºC)
- Wait for the bed to cool down before remove the piece
