Description
eSUN ePLA Matte ReFilament – 1.75mm 1kg Spooless
NOTE: This filament requires printing in slow speed 40-50 mm/s and temperature at 205℃ -215℃ to achieve best results. Direct drive is preferred as the material is softer than regular PLA.
Introducing Matte PLA Filament by eSUN
ePLA-Matte is a cost-effective PLA material that is environmentally friendly and easy to print. ePLA-Matte has high rigidity and does not require an enclosure. It has low shrinkage, no warping or cracking, and is suitable for large-size model printing. The support is easy to peel from the surface with a smooth and flat contact surface. There will be no irritating odor during printing, which is safe and environmentally friendly.
The matte surface is delicate and does not show layer lines. The filament is not easy breakable, which contributes to a smooth printing experience. It can be used for early concept models and rapid prototyping. Low density, ePLA-Matte single-roll consumables are 21% more than other matte PLA product print models.
Note: ePLA-Matte lines are softer than other lines, so the extruder’s tightness adjustment should not to be too tight, in case to affect printing.
Features:
- Environmental friendly
- Cost-effective
- High-speed printing
- Easy to peel off the support
- Excellent printability
- Hard to break
- Matte surface effect
- Low density
|
3D PRINTING FILAMENT |
ePLA-Matte |
| Density(g/cm3) | 1.174 |
| Heat Distortion Temp(℃,0.45MPa) |
51 5/10 |
| Melt Flow Index(g/10min) | 2.1（190℃/2.16kg） |
| Tensile Strength(MPa) |
34.56 3/10 |
| Elongation at Break(%) |
56.1 5/10 |
| Flexural Strength(MPa) |
41.21 4/10 |
| Flexural Modulus(MPa) |
1119.41 2/10 |
| IZOD Impact Strength(kJ/㎡) |
33.15 7/10 |
| Durability | 4/10 |
| Printability | 9/10 |
| Extruder Temperature(℃) |
190 – 230℃ Recommended temperature 215℃ |
| Bed temperature(℃) | 45 – 60°C |
| Fan Speed | 100% |
| Printing Speed | 40 – 100mm/s |
| Heated Bed | Optional |
| Recommended Build Surfaces | Glass, PEI, BuildTak, Kapton |
Click here if you would like to 3D print the spool (please select Second Generation model)
Commonly purchased together with:
- eSun eSpool for ReFilament
- eSun eVacuum Kit (10 Vacuum Bags)
- eSun eBox Filament Smart Storage and Dryer
